Tc-electronic TonePrint Editor Manuel d'utilisateur télécharger pdf (Page 17)

■

Reverb parameters

TC Electronic TonePrint Editor

■

Manual for software version 1.0 15

Reverb parameters

Use the parameters in the Reverb section of the

TonePrint Editor window to configure the reverb

effect.

Decay parameter

Parameter range: 0.01 to 20 s

Use the Decay parameter to set the decay time of

the Reverb in seconds. The decay time is usually

associated with the time it takes the diffuse field

of a reverb to decay to -60 dB.

PreDelayShort parameter

Parameter range: 0 to 100 ms

The PreDelayShort parameter is only applicable

when the Pre-Delay switch on the pedal has been

set to the “Short” setting.

Use the PreDelayShort parameter to define a

short delay placed between the direct signal and

the Reverb’s diffuse field. Use the PreDelayShort

parameter to keep the source material clear and

undisturbed from the scattered diffuse field of the

Reverb arriving shortly after.

PreDelayLong parameter

Parameter range: 0 to 100 ms

The PreDelayLong parameter is only applicable

when the Pre-Delay switch on the pedal has been

set to the “Long” setting.

Use the PreDelayLong parameter to define a

short Delay placed between the direct signal and

the Reverb’s diffuse field. Use the PreDelayLong

parameter to keep the source material clear and

undisturbed from the scattered diffuse field of the

Reverb arriving shortly after.

Diffuse parameter

Parameter range: -50 to 50

Use the Diffuse parameter to fine-tune the density

of the reverb’s diffuse field. It allows you to reduce

flutter in the diffuse field to an absolute minimum.

LoColor parameter

Parameter range: -50 to 50

Use the LoColor parameter to adjust the low fre-

quency spectrum of the output signal. This can be

used for altering the overall color of the reverb.

HiColor parameter

Parameter range: -50 to 50

Use the HiColor parameter to adjust the high fre-

quency spectrum of the output signal. This can be

used for altering the overall color of the reverb.

HiFactor parameter

Parameter range: -25 to 25

Use the HiFactor parameter to emphasize or at-

tenuate the selected HiColor value.

Mod On/Off parameter

Use the Mod On/Off parameter to switch modula-

tion of the reverb signal on or off.

The algorithm designers at TC have adjusted the

diffuse field part of the reverb to be as smooth

and natural sounding as possible. Adding in mod-

ulation to the reverb tail allows for interesting ef-

fects that can be refined using the Modulation

Rate and Modulation Depth parameters.

Modulation Rate parameter

Parameter range: -25 to 25

Use the Modulation Rate parameter to offset the

speed of the LFO that is being used to modulate

the Reverb.

This parameter only has an effect when you have

set the Mod On/Off switch to On.

Modulation Depth parameter

Parameter range: -25 to 25

Use the Modulation Depth parameter to offset the

intensity of the modulation that is applied to the

reverb.

This parameter only has an effect when you have

set the Mod On/Off switch to On.

1 2 ... 12 13 14 15 16 17 18 19

Commentaires sur ces manuels

Pas de commentaire

Tc-electronic TonePrint Editor Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de musique Tc-electronic TonePrint Editor